Re: Fuse box / Body Computer question

**PNL** · 09-15-2010

Originally Posted by MEP

Hiya. Siren just comes with it, I wasn't complaining, but you could connect it to the horn if you want it to sound like a Ford from the 90's.

Right fus box door pannel is 4 torex screws, and lower shroud had lugs you have to break to remove. I just cable tied it back up. Small back box? Is that for the ultrasonic sensors? I'm not going to say where I placed my control pannel for security reasons, but tbh you can place it where ever you want providing wiring reaches.

As for the ultrasonic sensors, they sit at the top of the 'A' pillars. Have tabs to slide under the roof lining.

Jon.

Thankyou Jon for that excellent post..

**jaffa89** · 09-16-2010

Thanks for your reply :-). Just got started now, trying to figure out what pin is number 1 on the canbus 32pin connectr to figure out the rest, any ideas :-p?

**jaffa89** · 09-16-2010

Near enough done now :-), just the horn to be wired up. What does the anti-hijack button do? Thanks.

**jaffa89** · 09-16-2010

Its all working bar the horn/siren, dont know whether this was because I was testing it with the door open or what.

**MEP** · 09-16-2010

Pin's are numbered on the plug (numbers are small, and at each end).

Anti-hijack I didn't bother with as I always have the doors on 'drive lock' anyways.

As for the latter, what have you wired in? Horn won't work if siren is selected on the jumpers.

**jaffa89** · 09-16-2010

Found the numbers after sitting looking for them for about an hour lol.

Okies, ill look into it, probs wont fit it anyway as I do the same.

I checked the jumpers and the horn is selected, the instructions say to use pin 1 of the 12, looking at the pins and reading the outputs shouldnt it be 6? there seems to be no feed from the control unit when the alarm is armed and activated tho.